User`s manual

Parameter description
6
6-2
6. Parameter description
6.1.2 Operating the digital operator
(1) Changing the monitor mode display and parameter setting
The button marks over/under the right/left arrows (
) or at the side of the up/down
arrows (
) show that those buttons were pressed. To save data you have entered
always be sure to press the
SET
key. Pressing the
FUNC
key will not save the data but
retains the previous value.
s 3
SET
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
SET
SET
SET
Note 5)
When the key is pressed in monitor mode (d-xx), the parameter
data displayed at that time will automatically appear the next time
power is turned on. This setting can be cancelled by setting another
parameter in monitor mode or by clearing the alarm log.
Blinking
Blinking
Note 1)
Note 3)
Blinking
Note 3)
Blinking
Hierarchy 1 Hierarchy 2
To enter a negative value, place the cursor at the leftmost
digit and change the polarity by pressing the or
key. If the data is 0 at this point, it is not set to "–0" but to
the maximum negative value (–5000).
Note 2)
Hierarchy 3
Note 1: When the
FUNC
key in hierarchy 1 is held down, the hierarchy changes in
order, from hierarchy 2
→
hierarchy 3
→
hierarchy 2
→
hierarchy 1. The
parameter name displayed after pressing the
FUNC
key at FA--- (hierarchy 1)
will be the parameter name that was last displayed at hierarchy 3 (if up to
hierarchy 3 was displayed).
Note 2: The blinking digit indicates the current cursor position.
Note 3: Pressing the
SET
key saves the data you have entered.
Pressing the
FUNC
key cancels the data you have entered and retains the
previous value.
Note 4: When changing a parameter (FA-12, FA-13, etc.) from "100" to "001", the
minimum setting range prevents changing it from the higher-order digit to
"000". So, first set it to "101" and then change it to "001".
Note 5: To quickly move from the monitor mode display (d-xx) to the parameter
setting mode (FA to Fd) use the
or keys.