User`s manual

Appendix
5
5-4
5. Appendix
5. When the following dialog box appears, click the [OK] button.
6. Click the [Close] button.
7. Connect the PC card RS-232C cable to the robot driver connection cable and then
click the [Connect] button to make the connection.
If the connection is not properly made, check the COM port assigned to the PC card and
the communication baud rate, data bit, stop bit and parity settings for the robot driver.
Check that the PC settings match those on the robot driver, and then retry the
connection.
You do not have to repeat the above procedure unless you reinstalled the TOP software.
From the next time onward, just click the [Connect] button to make the connection after
starting the TOP software.