User`s manual

3-21
3
Operating Procedures
3. Operating Procedures
3.4.4 Setting the operation trace conditions
To set the operation trace conditions, open the "Trace setting" window as explained
below.
Select "Trace setting" from the "Trace operation" menu or click
on the toolbar.
After setting the trace conditions by referring to the procedures below, click the [OK]
button to close the "Trace setting" window.
(1) To set the analog trace conditions:
1. Select the check boxes for channels you want to enable.
Up to 4 channels of analog data can be traced.
2. Select the trace item from the "Trace object" drop-down list.
For details on the trace items, see the trace item table shown in 3.4, "Operation
trace function".
3. Select the display graph No. (1 or 2).
(No.1 is displayed in analog 1 display area, while No.2 is displayed in analog 2
display area.)
4. Set the display color as desired.
5. Change the label name as needed by entering it directly into the field.
6. Select the channel for triggering.
1 2 3 4 5 6