User`s manual

Operating Procedures

3-2

3. Operating Procedures

Note 1: The PC will not connect to the robot driver if any screen other than the

opening screen is already displayed.

Note 2: Applicable robots for the RD series robot drivers are as follows:

(See the robot driver user's manual for detailed information.)

RDX-05, RDX-10, RDX-20 .... Robot drivers for rotary motor

RDP-05, RDP-10, RDP-20 .... Robot drivers for linear motor

3. Click the [Connect] button to connect to the robot driver.

When connected correctly, the screen changes as shown below after a few seconds to

make more buttons available on the opening screen. The [Connect] button also

changes to [Disconnect] button.

If failed to connect correctly, see section 4.1, "If failed to connect to the robot driver".

Selectable buttons