Instruction manual

CHAPTER 5 Appendixes
5 - 5
5- Although the following dialog box opens, click the [OK] button.
6- Click the [Close] button.
7- Connect the PC card RS-232C cable to the servo drive connection cable.
Click the [Connect] button to establish the connection.
If the connection is not properly established, check the COM port assigned to the
PC card and the communication baud rate, data bit, stop bit, and parity settings for
the servo drive. Ensure that the personal computer and servo drive agree have the
same settings, and then try again to establish the connection.
The above procedure need not be repeatedly performed unless you uninstall Setup
Software AHF. From next time on, just click the [Connect] button after Setup
Software AHF startup to establish the connection.