Instruction manual

CHAPTER 5 Appendixes
5 - 4
5.2.1 Connection procedures and precautions
(1) Installing the PC card
Install the PC card as directed in its documentation. Note what COM port the PC
card RS-232C is assigned to in the installation process.
(2) Connecting Setup Software AHF
When you install and launch Setup Software AHF, COM1 is set up as the
communication port. Therefore, change the assigned COM port to the above-
mentioned COM port the PC card RS-232C and establish the connection by
performing the following procedure (which presumes that the PC card RS-232C is
assigned to COM2):
1- Launch Setup Software AHF.
2- Click the [Communication format] button.
3- Set the communication port to COM2.
4- Click the [Setting] button.