Instruction manual

CHAPTER 3 Operating Procedures

3 - 28

2- Enter the speed command for jogging in field 2 below.

3- Conform the safety and then click a button to specify the desired direction of

operation (see 3) in the figure below). (The servomotor then starts rotating in the

specified direction.)

NOTE: Since this step causes the servomotor to run, confirm the safety beforehand.

Upon completion of the above step, the contents of the window change as

indicated below.

4- When you click the [Stop] button, the servomotor stops (servo OFF) (see 4) in the

figure below).