Instruction manual

CHAPTER 3 Operating Procedures
3 - 23
3.4.4 Operation trace setup
The trace setup window can be opened as directed below:
Choose [Trace operation (T)] on the menu bar and then choose [Trace setting (O)], or
click
on the toolbar.
After completion of setup, click [OK].
(1) Analog trace setup procedure
1- Check the channels to be validated (by entering a check mark in the
associated check boxes). Up to four channels of analog data can be traced.
2- From the drop-down menu, choose a trace target.
Refer to [3.4 Operation Trace Function] about the candidate for trace.
3- Select a display graph number (1 or 2) (No.1 is displayed in the area 1 and
No.2 is displayed in the area 2.).
4- Displayed color is selectable.
5- Label name is changeable by inputting directly.
6- Check the channel for triggering.
1-
2-
3-
4-
5-
6-