Instruction manual

CHAPTER 3 Operating Procedures
3 - 21
3- Start an operation trace.
To do this, choose [Trace operation (T)] on the menu bar and then choose [Trace
Start (S)], or click
on the toolbar.
When an operation trace starts, the above message appears.
4- When you click the trigger condition button or [Manual trigger] button in the above
dialog box, the servo drive transfers data to the personal computer and the
following dialog box opens.
NOTE1: Since the sampling cycle is short, the screen of “Trace operation was stopped!”
may not appear.
NOTE2: If you click the cancel button from the above dialog box, no graph will be drawn.