Instruction manual

CHAPTER 3 Operating Procedures
3 - 14
3.3.5 Loading the parameters
A file saved in a manner described in the preceding section can be used to set up the
parameters.
1- In the parameter setup window, choose [File (F)] on the menu bar and then choose
[Open (O)], or click the mouse on
on the toolbar.
2- When the Open window opens, specify the name of the file to load and its storage
location.
Note, however, that only CSV files can be loaded.
3- After the parameters are loaded from the specified file, the parameter data is
displayed in red as shown below if its value for the personal computer differs from
its value for the servo drive.
Those values are
shown by red.
Write the data as needed into the servo drive.