Instruction manual

CHAPTER 3 Operating Procedures
3 - 8
3.3.3 Editing the parameters
Two examples are presented in this section to explain about the parameter editing
procedure.
• Choosing from a drop list --- Example 1) Editing FA-00
• Inputting value directly --- Example 2) Editing Fb-00
(Example 1) Editing FA-00
1- Choose the FA tab, click the mouse on the FA-00 setting field, and select a new
setting from the drop-down menu.
Note 1) (0) showed after S-P means the value used in the servo drive internally.
Note 2) An error occurs on the screen when an attempt is made to rewrite write-
protected parameters while an operation is performed with the SON terminal
turned on.
2- Verify that the newly selected setting is displayed in red.
Changed value
becomes red and
symbol “*” is
attached to the right
side of the value.