Instruction manual

CHAPTER 3 Operating Procedures
3 - 2
3. Operating Procedures
3.1 Launching and Exiting
3.1.1 Launching the software
1- From the menu on the task bar, choose [Programs (P)], point to [Ahf], and then
click [Ahf].
2- The software then starts and opens the following window:
Connection
button
3- To connect to the servo drive, click the [Connect (C)] button. When the connection
is established normally, the following window opens in several seconds, offering
you an increased number of selectable buttons.
If the connection is not properly established, see Section 4.1, If the Servo Drive
Cannot Be Connected.
Selectable
buttons