User`s manual

system, or transmitted in any form or by any means(electronic, mechanical, photocopying, recording or otherwise)

without the prior written consent of RATOC Systems,Inc.

Trademarks

-Windows is a trademark of Microsoft Corporation, registered in the U.S. and other countries.

-USB2.0 Hi-Speed logo is a registered trademark of Universal Serial Bus Implementers Forum.

-`CardBus`, PC Card logo and CardBus logo mark are registered trademarks of PCMCIA/JEITA.

-Other logo, brand, product names may be registered trademarks or trademarks of their respective holders.

Changes

The information in this User’s Manual is furnished for information only and is subject to change without notice.

RATOC Systems,Inc. reserves the right to make changes in the product design or product improvements without

reservations and without notification to its users. RATOC Systems,Inc. assumes no responsibility or liability for any

errors or inaccuracies that may appear in this document.

Regulatory Compliance Statements

I)FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

(1) Reorient or relocate the receiving antenna.

(2) Increase the separation between the equipment and receiver.

(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

(4) Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance may

result in this unit not complying with FCC Rules Part 15.

II)European Union Compliance Statement

This device complies with EN55022 Class B/EN55024.

U.S.Patent Nos.4,603,320

4,686,506 and 4,972,470

Appendix