User`s manual

3-6. Confirming the driver(MacOS X 9.2.x)

The CBU2 on MacOS 9.2.x doesn’t support USB2.0 High speed. The CBU2 on MacOS 9.2.x works

as the USB1.1 compatible host adapter. To confirm the driver for USB1.1 is installed in MacOS 9.2.x,

check the following:

Open [Apple System Profiler] from the Apple menu and then click the [Devices and

Volumes]. If you can find a “USB” string as shown below, you can use the CBU2

To connect a USB device, proceed to Chapter 4.Connecting a USB device.

To remove the CBU2 from the PC Card slot, proceed to Chapter 5.Removing the

CBU2.

If you can’t find the string, you need to install USB driver available through Apple web site.

To install the USB driver through Apple web site, follow the steps 1-6:

1. Access to Apple web site(www.apple.com) and click the [Support] tab. Then, click [Down-

loads] and type in [USB Adapter] at Search for Downloads box. Click the [Go] button.