User`s manual

8
draobrehtomanosemannipfosmreT
foemanehT
elbacdeldnubeht
.cte,REWOP,V5)+(,REWOPBSU,CCV
."rewoP"gnitacidnidrowadniF
)SUBV(DER
.cte,)rebmunsnaemn(nMD,)rebmunsnaemn(-nDBSU,-BSU,-ATAD
."suniM"gnitacidnidrowadniF
)-D(etihW
.cte,)rebmunsnaemn(nPD,)rebmunsnaemn(+nDBSU,+BSU,+ATAD
."sulP"gnitacidnidrowadniF
)+D(neerG
.cte,dnuorG,DNG )DNG(kcalB
Please note USB2.0 pin assignment or pin names vary in different mother
boards. If your pin assignment or pin names are different from Fig1. shown in
the previous page, refer to the table below. Be sure to read user’s manual
that accompanied your mother board for more information.
(3)Connect the USB2.0 connector to the rear panel of the U2-MDK1U as shown
below.
rear panel of the U2-MDK1
Proceed to Chapter 3.Installation after connecting it.