User`s manual

4
(1)After attaching the HDD at Chapter 2-1, confirm your computer is turned off.
Then, attach the U2-MDK1 to a 5 inch bay as shown below.
(2)You need a power cable for the U2-MDK1U only. You should not connect
other devices other than the U2-MDK1U to the power cable.
Connect the cable to the power connector on the rear panel as shown below.
Refer to [Connecting a HDD power cable] in the next page for more
information. After connecting the cable, proceed to Chapter 2-3.
Power Connector
USB2.0 port
2-2.Attaching the U2-MDK1U to your computer