Instruction manual

Operations to control recording
5-11
9. When you are recording to memory, the message “Do you copy data?” Is displayed. If you click Yes,
the Copy dialog box is displayed. Use this dialog box to copy the data to the media or PC. (See the next
page for details.) If you again record data or power off the main unit before copying, the data in memory will
be lost. Alternatively, the data in memory will be lost if you playback.
If you have selected the Auto Saving option (after choosing File and then New) and the media has been
inserted, the above message will not be displayed and the data in memory will be automatically saved to the
media.
The above procedure records the files shown in the following diagram.
Exchanging Media
■ When Recording to Media
When the media becomes full during recording, a message will be displayed and the recording will stop.
The file up to that point has been completed. You can then replace the media and restart recording.
■ When "Auto Saving" Is Selected
When the media becomes full during copying, a message will be displayed and copying will stop. The file up
to that point has been completed. If you then replace the media, the remaining data will not be copied
automatically. In such a case, use the Copy dialog box to copy the remaining data. After replacing the media,
you can again start to record.
■ Directory and ID Number After Media has been Replaced
On the new media, the system will make the directory specified in the New dialog box and use the specified
file name. However, the ID number will again begin from 1. Also if the directory or file name specified in
the New dialog box already exists on the media, the last ID number is incremented by 1 and the new
sequential ID number is used.
REC
FWD
PAUSE
FWD
STOP
EVEN
T
Aaaaa001.dat
Aaaaa001.hdr
Aaaaa002.dat
Aaaaa002.hdr