Instruction manual

Operations to control recording
5-10
Operations to control recording
When you choose File and New, and then select the recording device and the file name, the mode becomes
the recording mode and you can start recording.
The following procedure shows how to record two IDs. Also, during recording, we will mark data by adding
event marks to the data.
1. Ensure that the mode shown in the status display is RECORD. If it is VIEW, click the REC button on the
far left of the window to change the mode to RECORD.
2. If data is saved automatically to the media after the recording to memory stops (that is, Auto Saving is
selected), or when recording to the media, ensure that the media is inserted.
3. Click the button on the toolbar. Alternatively, press the REC button on the main unit.
The action display will show RECSTANDBY, and the input waveform will be displayed in the waveform
display area.
4. After 3 seconds, click on the toolbar. Alternatively, press the FWD button on the main unit.
The action display will show REC and recording will start.
When recording to memory or recording to the media, the USAGE LEDs show the percentage of the total
capacity used.
5. Click on the toolbar. Alternatively, press the EVENT button on the main unit.
The display of the event mark count will show 0001. The number of scans at this instant is recorded in the
header file. The scan numbers are recorded on the header file. If a new event mark is not separated by the
previous mark by 2 or more seconds, the mark is not valid.
6. Click on the toolbar. Alternatively, press the PAUSE button on the main unit.
The recording of the first ID ends, and the system enters the pause status.
The action display shows RECSTANDBY.
When recording to the media, you cannot perform another recording until the system has finished writing to
the media.
7. Click on the toolbar. Alternatively, press the FWD button on the main unit.
The recording of the second ID will start.
8. After 3 seconds, click on the toolbar. Alternatively, press the STOP button on the main unit.
The recording will stop.