Instruction manual

Calibration By Using Calibrator
4-15
Calibration By Using Calibrator
You can use a calibrator or a piston phone to apply a sensor sensitivity based on the actual measurement at
the PA amp.
1. Click on the toolbar at the stop state of the LX main unit.
2. The Channel Unit table is displayed.
3. Click Calibration.
4. The Cal. Sound/Vibration dialog is displayed.
5. After the calibration has been performed, click Exit or click to return to the main window.
Select the channel.
Select the type of the sensor
to use.
Select to use RMS or Peak value
for calibration.
Set the output level to match to
the calibrator to be used.
Start calibration.
Being displayed the progress of the calibration.
Apply the calibration result to the slope value.