Instruction manual

Auto Offset
4-14
Auto Offset
The auto offset function of the LX Navi measures the voltage of each channel when clicking the Auto Offset
icon and then reflects its voltage value to the header file. The waveform data in the LX Navi displays Y-axis
data by adjusting to zero by using this offset value.
1. Click on the toolbar at the stop state of the LX main unit.
2. The Channel Unit table is displayed.
3. Click Auto Offset on the Channel Unit table at the timing to execute the offset. The LX measures the
voltages of the channels at the click timing and displays these values in the offset field
4. Click OK to apply the offset voltages displayed on the channels turning on their check boxes. The
Confirm dialogue is displayed.
Then click Y
es to set the values.