Instruction manual

Input Amp Settings

4-7

PA Amp AR-LXPA100

<PA100> is shown at the Slot tab.

AR-LXPA100 is a PA amp applied for some inputs such as voltage output accelerometer, etc.

See Section 6 for the specifications.

Cautions on Using PA Amp

■ Calibration

It is suggested that you use the 0.01 V range of the LX PA amp after turning on the power for 10 minutes or

more, and then executing manual calibration. In order to execute the manual calibration for precise

measurement, click the button on the toolbar of the LX Navi. Also it is recommended that you use the

balanced input mode for precise measurement. Also, the balanced input mode is recommended for precise

measurement.

■ Input Connection and Grounding

When using a battery-powered sensor or IEPE sensor

Input Mode: Balanced (Bal) mode

Whenever possible, connect the LX frame ground (FG) to ground.

When using the AC-powered sensor amp

Input Mode: Balanced (Bal) mode

Always connect the frame ground (FG) of the input signal source and the LX frame ground (FG) to ground.

■ Handling a reserved input terminal

Since the input impedance of the input amp is a high impedance of 1MΩ, there is a possibility that external

disturbance noise will be mixed with the data. You can set the maximum of the input range or short-circuit

the input to prevent interference by external noise.

AR-LXPA100

main

LXPA100