Instruction manual

System Settings
4-4
Calibration
When you set this to ON, the calibration will start automatically.
Clock
Use this to adjust the internal clock on the main unit. The current date and time according to the internal
clock are displayed here. To change the date, click the button on the right of the date. A calendar will ▼
appear. In the calendar, click the desired date. To change the time, click the digits you want to change and
then either type the desired time or click the or button on the right of the time to incre▲ ▼ ase or decrease
the time value. After you have changed the date or time values, click Set to apply the new settings.
Click PC to set the date and time of the PC connected.
Slot Use
Turn on a check box to enable the corresponding slot to be used for recording or reproduction. For Slot 1,
you can choose the number of channels to be used for recording from 2, 4, or 8.
Use the slot tab of the System dialog for the settings of the input and output amps enabled here.
At the LX-120, turn on the Tacho check box to enable the tachometer pulse input channels.
■ Yo u cannot use the tachometer pulse input channels and the generator output
function at the same time.
Same Setting
In case it is necessary to set amp for each channel, turn on the check box to apply the same settings to the
channels as the channel last changed.
Auto Zero Balance
In case a ST amp is installed, turn on the check box to start the zero balance automatically after settings
Adjust to PC Clock Before REC STANDBY
Turn on the check box to set the time of the LX main unit according to the PC