Instruction manual

Starting Program
2-14
For LX-100 Series (LAN model)
The following dialog box is displayed when LX Navi starts.
Check the box at the serial field LX Network dialog box by confirming that the white-out box has appeared
and the correct serial number are displayed, and then click OK. In addition, a previously used serial number
will automatically contain a check in the box.
If the whiteout box has not appeared, follow the next pages for a proper set up.
The upper part lists the LX-100 series that exist in the same segment. If you click where the IP address or
the name is displayed in the list area, the LX Property dialog box will appear. In this dialog box, you specify
settings, such as the IP address parameters and the recorder name (Name). Enter the address parameters
that match the network environment that you are using. For Name, you can use any string of up to 32
characters. This name is displayed in the list at startup. So, use a name that differentiates the particular
LX-100 series from any others. If the DHCP system is available for the network environment that you are
using, the IP Address parameters can be obtained automatically. So, in case that you want to set the IP
Address parameters automatically, turn on the check box of the DHCP. Consult your network administrator
to confirm whether or not the DHCP system is available for the network environment that you are using.
Click the OK button to apply the IP address parameters for the LX-100 series. It is not necessary to restart
the LX-100 series. It takes a few seconds for the changed settings to actually take effect. So, wait at least 5
seconds and then connect to the LX-100 series. If the list is not updated or the entry disappears from the list,
click the Update List button to update the list.