Instruction manual

Starting Program
2-13
Starting Program
After installing the drivers and LX Navi and connecting the PC and the LX, start LX Navi.
■ Do not run LX Navi together with application software that uses a lot of memory.
To start LX Navi:
1. On the LX-100 main unit, push up the power switch to |.
When the power is turned on, the input amp is automatically calibrated. During calibration, the input amp LED
will blink. When it finishes, the LED will turn off.
Then, the input amp LED turns off.
2. Start LX Navi.
After LX Navi starts, if you power off the LX-100 main unit or remove the IEEE 1394 cable, LX Navi will display
an error message and terminate. In such a case, if you turn the power back on or reconnect the cable, and then
restart LX Navi, the LX-100 can again be recognized.
In the case of the LX-100, if you power off the LX-100 main unit or remove the LAN cable, not only will
communications fail, but also the network will experience congestion in processing. Make sure to close LX Navi
first to detach the LX-100 from the network. Do not power off the LX-100 before closing LX Navi.
■ It is taking an excessively long time for the LED to turn off.
After you power on the main unit, if it takes an excessively long time for the input amp LED to turn off, the amp
may not have been recognized. In that case, turn the power on again.
■ Do not put the PC into sleep mode.
Set your PC's sleep mode to OFF. If the PC goes into sleep mode, an error will occur on the LX Navi. Make sure
the system standby setting in the screen saver or Windows power options is not selected. Note that some
notebook PCs automatically go into sleep mode just by folding the display.
For LX-100 Series (IEEE 1394 model)
Check the box at the serial field of the LX Network dialog box by confirming that the correct serial number is
displayed, and then click OK. In addition, a previously used serial number will automatically contain a check in
the box.