Instruction manual
Installing LX-100 Series (LAN model)
2-11
Installing LX-100 Series (LAN model)
An overview of the LX-100 (LAN model) installation is provided below.
1.
Install LX Navi.
2.
Set the IP address of the PC to be connected and the LX-100.
■ Use an on-board type 100BASE-TX LAN interface of your PC.
One-to-one connection with LX-100 using a cross cable
Installing LX Navi
To install the LX Navi software supplied:
1.
Set the supplied CD-ROM to CD/DVD drive. The program installation of the LX-100 Series will start to run.
If the program will not run, execute “Setup.exe” in the CD-ROM.
2.
Follow the instructions displayed and proceed with setup.
Click Ethernet at the dialog box that will appear in the middle of installation when using the LAN model and,
then, click OK.
3.
After the installation, restart the PC.