Instruction manual

Installing LX-100 Series (IEEE 1394 model)
2-4
Installing LX-100 Series (IEEE 1394 model)
An overview of the LX-100 (IEEE 1394 model) installation is explained below. Follow the installation
procedures explained later for each operating system.
1. Attach the interface card to your PC.
2. Install the OHCI driver.
3. Install the LX-100 Series device driver.
4. Install the LX Navi.
Installing Interface Card
Attach the PC card to your note PC
Insert the IEEE 1394 interface card CBFW3 to your PC card slot met the CardBus specification.
Check with your PC manual for the PC card slot information.
■ You may not insert the IEEE 1394 interface card with other types of PC card at the same time.
■ You may not install it in the upper slot.
■ Be careful when inserting it in your PC. The interface card or your PC may be damaged, if you force it
when inserting it.
Attach the PCI card to your desktop PC
Insert the PCI type interface card PCIFW3 in the PCI slot of your desktop PC.
Check with your PC manual for the PCI slot information.
■ Replace a standard bracket by the supplied low profile one when installing the PCIFW3.
■ Be careful when inserting it in your PC.
The interface card or your PC may be damaged, if you force it when inserting it.