Instruction manual

Names and Parts
1-11
1 FG terminal
Connects the grounding wire.
2 MON OUT connector
Outputs in analog format the signal of a channel during recording-standby status, recording, or reproduction.
You use the supplied LX Navi software to select the channel you want to monitor. You can set the output
range in 0.1 V steps, from 1 V to 5 V. The same filter as used for the output is applied to this monitor output.
(Not available for analog output using low-speed sampling frequency series)
Outputs the generator output signal at the LX-120.
3 EXT TRIGGER IN connector
Inputs the trigger signal when using an external contact signal as the trigger to start recording.
4 Cooling fan
Exhaust fans used for cooling the main unit. Do not cover the outlet vent.
5 BU-81 connector (optional)
Used to connect the optional battery unit.
6 DC IN connector
Inputs power in the range of +11 to 30 V.
7 IEEE 1394 connector (for IEEE 1394 model)
Connects to a PC. Use a recommended interface card on the PC.
8 Connector for recording synchronization (optional)
It is used for recording synchronization.
9 AQ-VU synchronization connector (optional)
Used to control record start/stop and time setting.
10 DIGITAL CONTROL connector
Used when using a contact signal to control recording or reproduction.
11 100BASE-TX connector (for LAN model)
Connects to a PC. The LED-side of the connector flashes while communicating.
12 PULSE IN A/B connector (LX-120 model)
Connects tachometer pulse inputs.