Instruction manual

Troubleshooting
7-2
Troubleshooting
If you encounter one of the following problems, check whether the recommended actions solve the problem
before you request a repair.
Problem Possible cause and recommended action
No power. Check whether the DC voltage is low.
The LX Navi software does not recognize
the LX.
In case of IEEE1394 model, make sure that the IEEE 1394
interface card is one of the recommended cards.
In case of LAN model, make sure that both the LX and the
PC have matched IP addresses.
Power on the LX again, and then restart LX Navi.
The media is not recognized in the New
dialog box.
Make sure that the media is formatted.
Make sure you are using the specified media.
You cannot record to the media. Make sure that the media is inserted.
Make sure that the media is formatted.
The Auto Saving function for
automatically saving to the media is not
working.
Make sure that the media is formatted.
Make sure that the media is not full.
Make sure that the Auto Saving option is selected. Note
that turning off the power will disable the Auto Saving
option. You must enable it each time you turn the power on.
The buttons on the main unit are
disabled.
Make sure that panel is not locked (P LOCK button). If the
panel is locked, release the lock.
You cannot set the sampling frequency. Make sure that number of the channels you activate is larger
than available number of the channels at the sampling
frequency in case turning on the tachometer input channels.
If you perform the recommended action but the problem remains, contact TEAC's service department.