Instruction manual

File Format
6-22
Header File
Header files are ASCII-format text files containing information such as recording conditions. Header files are
based on the waveform-analysis software DADiSP format. It can be opened by Window’s application
software such as MemoPad or Notepad since it is a text format.
In a header file, each recording-condition entry is written on 1 line, with parameters separated by a comma
(,). An example of a header file is shown as follows.
■ Example of Header File (LX-110)
DATASET TEST0001
VERSION 1
SERIES CH1_LX10_DC100K,CH2_LX10_DC100K,CH3_LX10_DC100K,CH4_LX10_DC100K,
CH5_LX110_DC100K,CH6_LX10_DC100K,CH7_LX10_DC100K,CH8_LX10_DC100K
DATE 06-23-2001
TIME 16:32:55.00
RATE 1500
VERT_UNITS V,V,V,V,V,V,V,V
HORZ_UNITS Sec
COMMENT <LX-110>
NUM_SERIES 8
STORAGE_MODE INTERLACED
FILE_TYPE INTEGER
SLOPE 8.000000e-005, 8.000000e-005, 8.000000e-005, 8.000000e-005, 8.000000e-005,
8.000000e-005, 8.000000e-005, 8.000000e-005
X_OFFSET -5.0
Y_OFFSET 0.000000e+000, 0.000000e+000, 0.000000e+000, 0.000000e+000, 0.000000e+000,
0.000000e+000, 0.000000e+000, 0.000000e+000
NUM_SAMPS 59200
DATA
DEVICE LX-110
SLOT1_AMP AD_AMP,8,V1.00 ,V1.00
SLOT2_AMP DA_AMP,8,V1.00 ,V1.00
CH1_1 LX110_DC100K,RANGE=2V,FILTER=ON
CH2_2 LX110_DC100K,RANGE=2V,FILTER=ON
CH3_3 LX110_DC100K,RANGE=2V,FILTER=ON
CH4_4 LX110_DC100K,RANGE=2V,FILTER=ON
CH5_5 LX110_DC100K,RANGE=2V,FILTER=ON
CH6_6 LX110_DC100K,RANGE=2V,FILTER=ON
CH7_7 LX110_DC100K,RANGE=2V,FILTER=ON
CH8_8 LX110_DC100K,RANGE=2V,FILTER=ON
ID_NO 1
TIME 20010623163255,20010623163335
REC_MODE MO
START_TRIGGER COMMAND,PRE
STOP_CONDITION COMMAND,POST
START_PRE_COUNT 7500
STOP_POST_COUNT 15000
MARK 100,200,300
ID_END
VOICE_MEMO 8BITS,327680
LX110_VERSION V1.00 ,V1.00 ,V1.00 ,00022E202000
MEMO_LENGTH 8,0,0,0,0,0,0,0
MEMO <LX-110>