Instruction manual

Recording Synchronization
5-36
Others
■ The LX Navi remembers the serial no. of the LX main unit which was operated previously. In such a case
in which the LX main unit is connected in the same segment, displaying a check-mark initially, clicking the
“OK” button only once will start the system.
■ As the LX Navi remembers the settings of the LX main unit’s synchronization operation by one setting,
confirming the sync. operation by only clicking “Sync Check” is required. (The selection of master / slave
can be omitted on future occasions)
 To use the LX main unit, which is in synchronization setting, as a standalone operation unit (no sync,
operation in normal), right click the “sync select” cell of the corresponding LX (“NO SYNC” will be
displayed) to start the “sync check”. Since the main unit remembers the settings by one operation, only
the normal starting procedure is required on future occasions.
■ The figure above indicates that the row of “sync select” has been right clicked to change the serial
no.107100 from a synchronization operation to a standalone one. Now, click the “Sync Check” button.
■ While the LX selection dialogue (LX Network) is displayed, click the “Sync Check” button to display the
result of confirming the synchronization connection in the item called “status”. The “CHECK” is displayed on
the master unit in which the synchronization connection is confirmed, and the “OK” is displayed on the slave
unit to which the proper connection has been confirmed. In case “NG” is displayed on the slave unit,
ensure that the synchronization connection cable has been connected properly, and click the “Sync Check”
button again to confirm the synchronization connection.
■ To reconfirm the LX in the same segment after displaying the LX selection dialogue (LX Network), click
the “Update List” button. (On the assumption that you have started to run the LX Navi and have turned on
the LX, you should click the “Update List” button to reconfirm the LX in the same segment.)
In case the LX main unit, which has been created settings of synchronization, is used as a
standalone operation without applying the settings above, the system might become to operate
unstable. Make sure to perform the operations to change the settings to a standalone one.