Instruction manual

Recording Synchronization
5-35
4. To show the window of the LX specified as a slave unit, start again to run the LX Navi on the PC to display
the LX selection dialogue (LX Network) mentioned in Step 1. Then, click the box in <serial> field of the LX
main unit specified as a slave unit, and click [OK]. (If the check box has a check-mark with grey background,
click it twice to change it to a normal check-mark and click [OK].）
The LX Navi main window of the slave unit is displayed. “S*/name or serial number” at Target Unit in the
left bottom of the window is displayed, and the main window belongs to the slave unit.
By the same operations, open the main window of the other slave unit that is connected. Set the recording
parameters of the master and slave units one by one by maximizing and minimizing their main windows.
5. After setting the recording parameters of each unit, keep the main window open of the master unit and the
necessary main windows of the slave units to be monitored. Close the unnecessary main windows of the slave
units.
Operate the main window of the master unit to start and stop the recording synchronization of the multiple
units.
6. To terminate the LX Navi, quit them in the reverse order of the starting order (slave N…,
slave2,slave1,master ).