Instruction manual

Contents of Displayed Message
5-22
Contents of Displayed Message
Type Displayed Messages Meanings Actions to be taken
INF Succeeded to adjust time. Succeeded in updating
the
date and time
Confirm the date and time displayed
QUE
Do you adjust time on LX with PC
clock?
Do you wish to adjust the
time on the LX with the
PC
clock?
Se
lect the “Yes” button to adjust the time on LX with the
PC clock.
QUE Do you copy data? Do you wish to copy data?
Select the “Yes” button to save recording data on media
or PC.
QUE Do you set file name?
Do you wish to specify the file
name? (For copy operation)
Select the “Yes” button to specify file name to continue
the copy operation.
QUE There is same path name.
Do you overwrite data?
The same file name already
exists.
Do you want to
overwrite the file?
Select the “Yes” button to overwrite
the file with the
same name.
WAR Cannot find amplifier unit. Amplifier is not installed.
Confirm that the amp is installed properly and restart the
LX main unit.
WAR Cannot reproduce this file. Cannot reproduce this file This file includes attribut
e data, which cannot be
reproduced.
WAR Check Start PreTrig Value. Check the pre-trigger value Check the pre-trigger setting and change it.
WAR Couldn't close this application.
Please set REC (IDLE) MODE.
Couldn’t close this
application. Make the
recording mode idle.
Make the recording mode idle and close the application.
WAR Device Not Selected.
The device is not selected as
the copy destination.
Specify the device as the copy destination and restart
again.
WAR Failed to create new file.
Please confirm the file path.
Failed to create new file.
Confirm the file path name.
Failed to create new file. Confirm the specified file path
name and that the device are writable, and restart again.
WAR Failed to perform zero balancing.
Please confirm a result.
Failed to perform zero
balance. Confirm the result in
start zero balance window.
“NG” is displayed on one or more channels as a result of
zero balance. Open the start zero balance window to
confirm the channel with “NG” and restart again. T
he
channel with open status might result in “NG”.
WAR File increment number overflow.
Move a figure some place to the
left.
The file increment number
has overflowed. Specify to
increase the number of digits
in the ID number
The number of the file numb
er is reaching the upper
limit. In order to increase the number of digits in the ID
number, specify it and start again.
WAR Input parameter is invalid.
The input parameter is invalid
Modify the parameter with the cursor.
WAR Low battery.
Please close this application.
The battery voltage is low .
Close this application.
The power of the LX main unit might be turned off. Close
the running task to finish the application.
WAR LX Dataset name is invalid.
The file name of the media is
invalid.
Confirm whether or not the file name of the
LX media for
recording includes prohibited characters and change them
if required.
WAR LX Directory name is invalid.
The
Directory name of
the
media is invalid.
Confirm whether or not the directory name of the
LX
med
ia for recording includes prohibited characters and
change them if required.
WAR Media full.
The m
edia installed in LX main
unit is full.
If you keep recording further, replace the media with a
new one.
WAR Media Not Ready.
Media is not ready. Cannot
enter REC STANDBY.
Confirm to install media and the status enters “Media
Ready”. Then, start to run.