User manual

S
-95-
COMMON
Copying unit software from PC to CM Flash-Box
- Open lid of the Flash-Box
1. - Set DIP - switch 2 to „ON“.
(other switches remain in the off
position)
2. Connect RS 232 adapter cable (item 2) to Flash-Box and to the selected
interface (e. g. COM 1) of the PC
3. Start program Megaload and open fl ash software (e.g.: C-1-06.02.hex)
4. Connect USB-cable (item 3) to fl ash box and PC
5. After the USB cable was connected the fi les which are transferred will appear
on the Message window. An end sign indicates that the transfer is completed.
6. On the fl ash box set DIP- switch 2 to OFF and 3 to ON (the other switches
remain off). Flash-Box is ready for use
Update unit software with CM Flash-Box to unit
1. Switch off unit with mode switch and open front panel.
Check that DIP 3 is in the ON position.
2. Connect Flash-Box to RS 232 interface of the operator pcb.
3. Switch on CM unit. After the software update is completed the unit switches
off and back on again.
4. Now the Flash-Box can be removed and the unit can be used.
1
2
3
4
on
on
X7
X19
X20
X18
X23
X31
RS 485
X8
X12
X16
X17
X26
X27
X
3X32
X24
X24
X63
X63
F6.1
F6.1
F6
X3X4XX6
X2
X2
X50
X50
on
on
off
off
0,1 AT
0,1 AT
2 AT
X7
X7
X19
X19
X20
X20
F1
F1
F2
F2
0,1 AT
0,1 AT
2 AT
2 AT
Transformer
Transformer
X16
X16
42.00.004
42.00.047
X30
X30
RS 232
RS 232