User manual

-90-

COMMON

Flash SCC Software

The actual software version can be downloaded from:

www/rational-ag.de/service/technical_documentation/SCC-Line/Software

Software update by USB-stick

USB stick MUST be formatted in FAT (FAT16) format.

NOTE: Most standard USB Flash stick are not suitable for SCC Flash update!

RATIONAL conﬁ gured USB Flash memory stick can be ordered under

part number: 87.00.010

Software can only be updated to the next higher version. Flashing software versions prior to

the existing version is NOT possible!

NOTE!

Software update on a unit with unknown software version (in case a pcb from spare

part stock is used) or in case the external EEPROM was faulty please observe the

procedure on the following page.

For Standard Software Update please proceed as follows:

1. Switch unit on

2. Wait until the operator mode of the SelfCooking Center is displayed.

3. Connect the USB stick with the actual software version to the USB interface of the

Rational SelfCooking Center.

4. Switch unit off and on again.

The unit will display „UPDATE“ followed by „Please don‘t touch“.

After the operator mode of the SelfCooking Center is displayed the USB stick can be

removed from the unit.

Notes: Please make sure your customer has always the latest software on his unit.

Please make sure you have the latest update.exe dated December, 6th, 2004

(12.06.2004) on your USB memory stick.