User`s manual

Rastergraf
Introduction - 2
Getting Help
This installation manual gives specific steps to take to install your
Rastergraf graphics board. There are, however, variables specific to your
computer configuration and monitor that this manual cannot address.
Normally, the default values given in this manual will work. If you have
trouble installing or configuring your system, first read Chapter 4,
“Troubleshooting”. If this information does not enable you to solve your
problems, do one of the following:
1) call Rastergraf technical support at [phone]
2) fax your questions to [phone]
3) send E-mail to
[e-mail].
If your problem is monitor related, Rastergraf technical support will need
detailed information about your monitor.
Board Revisions
This manual applies to the following board revision levels:
Eclipse3PMC Fab Rev 1.2A
Eclipse3CPCI Fab Rev 1
Eclipse3PCI Fab Rev 0
Manual Revisions
Revision 1.0 March 19, 2001 First released version
Revision 1.1 March 25, 2001 Revisions
Revision 1.2 June 15, 2001 Minor revisions
Revision 1.3 June 25, 2001 Minor revisions
Revision 1.4 May 14, 2002 Updates for PMC 1.2
Revision 1.5 May 17, 2002 A few more changes
Revision 1.6 May 17, 2002 Release
Revision 1.7 May 17, 2002 Minor revisions
Revision 1.8 August 22, 2002 Noted Fab Rev 1.2a change for
M66EN
Revision 2.0 February 11, 2008 Created Rastergraf version. Many
detail changes