User`s manual

Rastergraf
2-22 Installing Your Peritek Graphics Board
2.9.2.3 Setting the Console Resolution
The initial system default console resolution of the Eclipse3 is 8 bits per
pixel, 1152 x 864 @ 60Hz. The Eclipse3 is capable of supporting
additional console mode resolutions (all are 8 bpp) as shown in the
following table:
Table 2-2 FCode Supported Display Modes
Index Graphics Refresh Rate PC Type
0
1024 x 768 60 Hz
UVGA
1
1024 x 768 75 Hz
UVGA
2 *
1152 x 864 60 Hz
Sun
3
1152 x 864 75 Hz
Sun
4
1280 x 1024 60 Hz
SXGA
5
1280 x 1024 75 Hz
SXGA
6
800 x 600 60 Hz
SVGA
7
800 x 600 75 Hz
SVGA
8 640 x 480
60 Hz
VGA
9 640 x 480
75 Hz
VGA
a
1152 x 900 60 Hz
Sun (old)
b
1152 x 900 75 Hz
Sun (old)
c
1600 x 1200 60 Hz
UXGA
d
1920 x 1200 60 Hz
WUXGA
Index * - initial system default
To change the startup console display mode, identify the desired graphics
resolution and refresh rate and enter the corresponding index value (e.g, 6
is the index value for 800 x 600 @ 60hz) in place of the word index, as
shown in the below.
[at the ok prompt]
type nvedit
receive 0: [if, instead, you receive 0: and some text, type <ctrl-k> to clear the line]
type index constant eclipse3-console-mode <return>
receive 1: [if, instead, you receive 1: and some text, just ignore it]
type ^C
receive ok
type nvstore
receive ok