User`s manual

Rastergraf
Installing Your Peritek Graphics Board 2-21
2.9.2.1 Getting Ready to Make the Changes
If you are running Solaris, shutdown and halt the CPU until the OpenBoot
prompt (ok) appears.
Then, disable the CPU from automatically booting until the configuration
process is completed:
ok setenv auto-boot? false
Set the OpenBoot input and output devices to recognize Eclipse.
ok setenv input-device keyboard
ok setenv output-device screen
2.9.2.2 NVEDIT Command Summary
The next section makes use of the OpenBoot nvedit utility to change the
default settings for the Rastergraf FCode that are maintained in the
nvramrc file by OpenBoot.
NVEDIT Commands
Ctrl-N Go to the next line
Ctrl-P Go to the previous line
Ctrl-A Go to the beginning of a line
Ctrl-L List the entire contents
Ctrl-K Deletes a line
Ctrl-C Exits the editor
Hitting the <Enter> key while in nvedit causes a new empty line to be
inserted in the nvramrc.
Important Note: in order for the changes that have been made in nvram
to take effect some processor boards (e.g., the Themis UltraSparcII) may
require the following to be added as the last line of the nvramrc.
probe-all install-console banner