Users Manual
Table Of Contents
- 97200 英文增加警告语_页面_18
- 97200 英文增加警告语_页面_19
- 97200 英文增加警告语_页面_20
- 97200 英文增加警告语_页面_21
- 97200 英文增加警告语_页面_22
- 97200 英文增加警告语_页面_23
- 97200 英文增加警告语_页面_24
- 97200 英文增加警告语_页面_25
- 97200 英文增加警告语_页面_26
- 97200 英文增加警告语_页面_27
- 97200 英文增加警告语_页面_28
- 97200 英文增加警告语_页面_29
- 97200 英文增加警告语_页面_30
- 97200 英文增加警告语_页面_31
- 97200 英文增加警告语_页面_32
- 97200 英文增加警告语_页面_33
- 97200 英文增加警告语_页面_34
MAINTENANCE
• Remove the batteries when the unit is not in use for long periods of time.
• Clean the vehicle with a soft cloth.
• Avoid being heated or being exposed to strong sunlight.
• Keep dry.
• Regularly examine the toy for any damage to its wires, plug, enclosure and other parts and they must not be used
until the damage has been repaired.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly a pproved by
the party
responsible for compliance could void the user’s
authority
to operate
the equipment.
29