User's Manual

FCC ID : 2AENTXH170515BT
This device
complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause
harmful interfere
nee, and
(2) this device must accept any interference received, including inte
rference that may cause undesired operation.
Frequency bands: 26.957MHz
to 27.283MHz or 40.660MHz to 40.700MHz.
Carrier Frequencies: 27.145MHz
or 40.68MHz.
Maximum Transmitting Power
(ERP): Not more than 10mW.
& WARNING:
CHOKING HAZARD-Small parts.
Not for children under 3 years.
changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.