Installation Guide

E-Labelling
It is possible for the Host product to use e-labelling providing the Host product supports the
requirements of FCC KDB 784748 D02 e labelling and ISED Canada RSS-Gen, section 4.4.
E-labelling would be applicable for the FCC ID, ISED Canada certification number and the FCC Part 15
text.
Changes in Usage Conditions of this Module
This device has been approved as a Mobile device in accordance with FCC and ISED Canada
requirement. This means that there must be a minimum separation distance of 20cm between the
Module’s antenna and any persons
A change in the separation distance to one that is less than 20cm between the user and the antenna
requires the host product manufacturer to re-assess the RF exposure compliance of the module
when placed in the host product. This needs to be done as module could be subject to a FCC Class 2
Permissive Change and a ISED Canada Class 4 Permissive Change in accordance with FCC KDB 996396
D01 and ISED Canada RSP-100.
As noted above, This device and its antenna(s) must not be co-located with any other transmitters
except in accordance with IC multi-transmitter product procedures.
If the device is co-located with multiple antennas, the module could be subject to a FCC Class 2
Permissive Change and a ISED Canada Class 4 Permissive Change policy in accordance with FCC KDB
996396 D01 and ISED Canada RSP-100.
In accordance with FCC KDB 996369 D03, section 2.9, test mode configuration information is
available from the Module manufacturer for the Host (OEM) product manufacturer.