Installation Guide

5. End Product Labelling
A label is to be fitted to the exterior of all products containing the Raspberry Pi Zero 2 module. The
label must contain the words “Contains FCC ID: 2ABCB-RPIZ2” (for FCC) and “Contains IC: 20953-
RPIZ2” (for ISED).
FCC
Raspberry Pi Zero 2 variants FCC ID: 2ABCB-RPIZ2
This device complies with Part 15 of FCC Rules, Operation is Subject to following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference that cause undesired
operation.
Caution: Any changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void user s authority to operate the equipment.
This equipment has been tested and found to comply within the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: • Re-orient or relocate the receiving antenna • Increase the separation between the
equipment and receiver
• Connect the equipment into an outlet on a different circuit from that to which the receiver is
connected • Consult the dealer or an experienced radio/TV technician for help.
For products available on the USA/Canada market, only channels 1 to 11 are available for 2.4GHz
WLAN