Datasheet

3
Raspberry Pi PoE HAT
raspberrypi.org
Warnings
Safety instructions
This product shall only be connected to a Raspberry Pi 3 Model B+ or later.
Any external power-sourcing equipment/power injector used to enable a Ethernet network shall comply
with relevant regulations and standards applicable in the country of intended use.
This product should be operated in a well ventilated environment and, if used inside a case, the case
should not be covered.
The connection of incompatible devices to the GPIO connection may affect compliance and result in damage
to the unit and invalidate the warranty.
All peripherals used with this product should comply with relevant standards for the country of use and be
marked accordingly to ensure that safety and performance requirements are met. These articles include
but are not limited to keyboards, monitors and mice when used in conjunction with the Raspberry Pi.
Where peripherals are connected that do not include the cable or connector, the cable or connector must
offer adequate insulation and operation in order that the relevant performance and safety requirements
are met.
To avoid malfunction or damage to this product please observe the following:
Do not expose to water or moisture, or place on a conductive surface whilst in operation.
Do not expose it to heat from any source. The Raspberry Pi 3 Model B+ and PoE HAT are designed for reliable
operation at normal ambient room temperatures.
Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and connectors.
Avoid handling the printed circuit board whilst it is powered and only handle by the edges to minimise the
risk of electrostatic discharge damage.
Physical specications
Note: all dimensions in mm