Datasheet

PN512 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
Product data sheet
COMPANY PUBLIC
Rev. 5.2 — 16 June 2016
111352 21 of 137
NXP Semiconductors
PN512
Full NFC Forum-compliant frontend
7.4.6 FeliCa Card operation mode
8. PN512 register SET
8.1 PN512 registers overview
Table 14. FeliCa Card operation mode
Communication
direction
FeliCa FeliCa Higher
transfer speeds
Transfer speed 212 kbit/s 424 kbit/s
reader/writer 
PN512
Modulation on reader side 8-30 % ASK 8-30 % ASK
bit coding Manchester Coding Manchester Coding
Bitlength (64/13.56) s (32/13.56) s
PN512  reader/
writer
Load modulation on PN512
side
> 12 % ASK load
modulation
> 12 % ASK load
modulation
bit coding Manchester coding Manchester coding
Table 15. PN512 registers overview
Addr
(hex)
Register Name Function
Page 0: Command and Status
0 PageReg Selects the register page
1 CommandReg Starts and stops command execution
2 ComlEnReg Controls bits to enable and disable the passing of Interrupt Requests
3 DivlEnReg Controls bits to enable and disable the passing of Interrupt Requests
4 ComIrqReg Contains Interrupt Request bits
5 DivIrqReg Contains Interrupt Request bits
6 ErrorReg Error bits showing the error status of the last command executed
7 Status1Reg Contains status bits for communication
8 Status2Reg Contains status bits of the receiver and transmitter
9 FIFODataReg In- and output of 64 byte FIFO-buffer
A FIFOLevelReg Indicates the number of bytes stored in the FIFO
B WaterLevelReg Defines the level for FIFO under- and overflow warning
C ControlReg Contains miscellaneous Control Registers
D BitFramingReg Adjustments for bit oriented frames
E CollReg Bit position of the first bit collision detected on the RF-interface
F RFU Reserved for future use
Page 1: Command
0 PageReg Selects the register page
1 ModeReg Defines general modes for transmitting and receiving
2 TxModeReg Defines the data rate and framing during transmission
3 RxModeReg Defines the data rate and framing during receiving
4 TxControlReg Controls the logical behavior of the antenna driver pins TX1 and TX2
5 TxAutoReg Controls the setting of the antenna drivers