Data Sheet
7.5
2.75
6
9
27
45.75
56
49
4
12
24.5
20.5
3.5
3.5
7.7 14.8 13.5
3.5
3.5
CORNER RADIUS = 3.0MM
85
58
29
29
25.75
32.5
7
11.5
6.14
z=3.0
z=3.0
z=3.2
z=5.5
z=5.5
z=2.4
z=6.0
z=16.0
z=16.0
z=13.5
z=8.5
www.OKdo.com
R ASPBERRY Pi 4
TECHNICAL DATA
PHYSICAL SPECIFICATIONS
Warnings
This product should only be connected to an external power supply rated at 5V/3A DC or 5.1V/ 3A DC minimum
*
. Any external
power supply used with the Raspberry Pi 4 Model B shall comply with relevant regulations and standards applicable in the
country of intended use.
This product should be operated in a well-ventilated environment and, if used inside a case, the case should not be covered.
This product should be placed on a stable, flat, non-conductive surface in use and should not be contacted by conductive
items.
The connection of incompatible devices to the GPIO connection may affect compliance and result in damage to the unit and
invalidate the warranty.
All peripherals used with this product should comply with relevant standards for the country of use and be marked accordingly
to ensure that safety and performance requirements are met. These articles include but are not limited to keyboards, monitors
and mice when used in conjunction with the Raspberry Pi.
Where peripherals are connected that do not include the cable or connector, the cable or connector must offer adequate
insulation and operation in order that the relevant performance and safety requirements are met.
Safety instructions
Do not expose to water or moisture, or place on a conductive surface whilst in operation.
Do not expose it to heat from any source; Raspberry Pi 4 Model B is designed for reliable operation at normal ambient
room temperatures.
Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and connectors.
Avoid handling the printed circuit board whilst it is powered and only handle by the edges to minimise the
risk of electrostatic discharge damage.
*
A good quality 2.5A power supply can be used if downstream USB peripherals consume less than 500mA in total.