User's Manual

UCI-MSD User manual
V1 10/2020
2 / 5
Installation and operation:
To operate UCI-MSD as intended, both USB data and power connection is required.
Both are provided by the USB-host device once the USB-A cable is plugged in.
1. Plugin the UCI-MSD receiver’s USB-Cable into the USB-Port of the receiving PC or USB-
Mass-storage capable device. A drive named “RECEIVER” will show up within max. 90
seconds after plugging in.
2. Plugin the UCI-MSD transmitter’s USB-Cable into the USB-Port of the transmitting USB-
Mass-storage capable device.
3. To verify if the sender(s) have successfully established a link to the receiver, check
available USB-drives for their name. Once ready, a ‘SENDER’ drive will appear on the
host where the transmitter is plugged in.
If the ‘SENDER’ drive does not appear, the link is not established correctly. In this case,
check if the receiver is plugged correctly and within range of the transmitter. Also, check
the label for the set-id. Both receiver and transmitter must have the same set-id.
4. Once the ‘SENDER’ drive shows up, the system is ready for operation.