User Manual

嵌入式蒸氣焗爐 Built-in Steam Grill Oven
– 32 – – 33 –
6. Operation Instruction
6.1 Standby mode
Once connected to the electricity, buzzer will sound “beep” for one time. All the buttons and icons on the display
will blink once while [ ] key will keep flashing, known as standby mode. If the appliance is left idle, [ ] key will
switch off and the power-saving mode will be activated.
Note: Press any key during power-saving mode, the appliance will resume standby mode and [ ] key will keep
flashing again.
6.2 Selection mode
Under standby mode, press the [ ] key for 1 second, buzzer will “beep” and the appliance will enter selection
mode while all accessible keys and icons will light up. User can access different cooking modes and auxiliary functions
accordingly.
6.3 First time of use
Before first use, make sure to operate the appliance empty in order to eliminate the smell of the new unit by the
below procedures:
1. Under selection mode, press Grill [ ] key to select Convection and Upper Grill ( ) cooking mode. Default
cooking temperature and time will be shown on display.
2. Press Temp./Time [ ] key once, cooking time indicators will blink. Press Increase [ ] or Decrease [ ] key to
set 15 minutes cooking time. Once finish, press Temp./Time [ ] key again, cooking temperature indicators
will blink. Press Increase [ ] or Decrease [ ] key to set 230℃ cooking temperature. Press Start/Pause [ ]
key once to confirm, Convection and Upper Grill ( ) will start to operate.
(Note: When operate the oven empty, smoke and smell may appear which is a normal phenomenon.)
3. Once finished, open the oven door, use the appliance until it is cooled down.
6. 4 Filling Water
Make sure to install the fill sufficient water in the water tank if STEAM or STEAM GRILL functions is needed.
Follow the procedures below to fill water:
1. Under selection mode, press the Water Tank[ ] key once, water tank will be popped out automatically. Pull
out the tank from the appliance horizontally.
2. Open the circle rubber lid and fill water to the maximum indicator “MAX”. Suggested to use distilled water
or purified water.
CAUTION! Water should not exceed the maximum indicator “MAX” of the tank.
3. Once finished, Cover the circle rubber lid and insert the tank in bracket to make it done.
Note:
• After taking out the tank, to avoid damage, recommended to wait for 15 seconds before putting back the
tank into the appliance.
• To avoid deformation, do not fill liquid with temperature 70℃ or above into the water tank.
• When the appliance is out of water during operation, Refill indicator ( ) will blink on the display with buzzers
to remind user refilling water.