Owner`s manual

View from behind burner

1. FRONT LOGS: Align the Front Log Guide Grooves (Figures 4 and 5) with right and left ends of the Front Burner

(Figures 4 and 5) and position the Front Logs between the Burner and the Grate Teeth as shown in Figure 8C. The

Front log has a small notch on the right and left sides to help align the log with Grate Teeth. (18” Log set used below

for example)

2. PAN MEDIUM: With Both Front Logs on the Grate as shown in Figure 8, below), pull the Ember Magic apart into

loose, thin pieces (Figure 6) and drape them over the Ember Lifter (Figure 7) completely covering the Burners.

ember material should be no more than one to two pieces of ember material in depth. To ensure proper ignition

and combustion and to enhance ember performance gently loosen & lift Ember Material with a screw driver after

approximately five minutes of burn time.

STEP THREE: LOG PLACEMENT (ALL MODELS)

●

NOTE: Thinner, less densely packed pieces of Ember Material will enhance the overall glowing ember effect, e.g., the

looser the pieces, the better the glowing ember effect as in Figure 6 above!

WARNING:

Excessive amounts of Ember Material or Ember Material which is too tightly packed, or exposed ports on Front

or Middle burner can result in decreased combustion performance and elevated levels of carbon monoxide.

Side View of burner

Ember Lifter

Guide Groove

View from behind burner

Notch

FIGURE 4

FIGURE 8

Guide Groove

Grate Teeth

FIGURE 5 FIGURE 6 FIGURE 7