Installation Guide

REV 11.14.2019

• Vinyl Flooring should remain at a temperature between 55°F - 85° F

(13°-29° C) during its service life.

• Adhesive types can have a significantly different moisture tolerance

which can influence required subfloor preparation well as install time.

• 4 mm and 5 mm thickness flooring can be installed loose lay with

perimeter R88 spray or G100 Trowelable adhesive. However, for large

areas, high traffic and commercial environments, we require a full-

spread application of releasable R88 spray adhesive or trowel-applied

G100 transitional PSA adhesive. Please use installation method

specified by design firm or end user.

• Use of our R88 & G100 PSA releasable adhesives means that

damaged tiles or planks can be easily removed and replaced. With

spray adhesive, there is no adhesive cure time, so projects can be

immediately occupied. RI 4 mm and 5 mm flooring contribute to a

quieter environment and all patterns are no-wax, no-buff, no strip. Just

sweep, vacuum or damp mop for long-lasting, colorfast and releasable

floor.

• RI flooring is very easy to cut by scoring with a sharp blade and

snapping or with a vinyl cutter. Avoid small perimeter pieces less than

6” in length and 3” in width.