Operation Manual

Model 140T/140F Owner’s Manual
EMC Part: 44000700 • Rev.02 • 04/19/06
37
ELECTRIC
MOBILITY
Stiffness in steering 1. Possible grime build up 1. Lubricate bearings
2. Bearings in head tube worn 2. Replace bearings
Controller Fault Codes
The controller used in Model 140T/140F includes internal diagnostics programming used to identify and troubleshoot
faults. When this diagnostics programming detects a fault, the LED status indicator on the dash flashes consecutively to
identify the fault. These consecutive flash codes correspond to a fault which are listed and described below.
LED Status Indicator Meaning and What To Do
1 (not used)
2 Battery Voltage Low. Check connections, and recharge batteries.
3 Battery Charge High. Unplug charger, turn scooter power on & off.
4 (not used)
5 Brake fault. Check Brake Release lever position and motor connections. Contact
authorized service facility.
6Out of Neutral at Power-Up. Engager not in neutral (centered) when keyswitch turned on.
Return lever to center and retry.
7 Speed Pot Error. Engager or wiring faulty or setup incorrectly. Contact authorized service
facility.
8Motor Voltage Error. Check all connections between controller and motor.
9Controller fault. Check all connections.