Operation Manual

Model 140T/140F Owner’s Manual

EMC Part: 44000700 • Rev.02 • 04/19/06

ELECTRIC

MOBILITY

Adjusting Handlebar Assembly

The angle of the handlebar assembly and dash may be adjusted to the individual rider’s preference. Multiple angles are

available to reposition the handlebar assembly. The handlebar assembly angle adjustment knob allows you to position the

handlebar assembly closer or further away for better access to the controls.

Figure 9 -Handlebar Assembly Adjustment

HANDLEBAR

ASSEMBLY

HANDLEBAR

ADJUSTMENT

KNOB

To Adjust Handlebar Assembly Position:

1. Locate the black angle adjusting knob located on the right

side of the handlebar assembly.

2. Hold the handlebar with one hand and loosen the hand

knob.

3. Adjust the angle of the handlebar assembly to a

comfortable position.

4. Turn the knob clockwise to tighten. As you tighten the knob

gently rock the handlebar assembly back and forth to allow

the teeth on the clamp to engage tightly.

5. Check the knob daily to ensure it’s tight.

Handlebar Assembly Adjustment is shown in Figure 9.